Wyoben

We are Wyoming Bentonite

Wyo-Ben

Call: 800-548-7055

Testing Equipment

7 Item(s)

List Grid 
Set Direction
  1. BASIC MUD KIT

    BASIC MUD KIT

    This “Basic Mud Kit” contains all the required equipment for basic onsite testing of water based drilling fluid. The handy plastic case keeps test equipment clean, dry and organized. Learn More
  2. DELUXE SAND CONTENT KIT

    DELUXE SAND CONTENT KIT

    DELUXE SAND CONTENT KIT - It is desirable to know the sand content of drilling muds because excessive sand may result in the deposition of a thick filter cake on the wall of the hole, or may settle in the hole about the tools when circulation is stopped, thus interfering with successful operation of drilling tools or setting of casing. Learn More
  3. JET HOPPER

    JET HOPPER

    Our 3" Jet (venturi) Hopper provides a quick and simple means of mixing dry materials into liquids. A low pressure area is created by increasing the flow velocity through the venturi nozzle. This low pressure draws the dry materials into the liquid stream where turbulent flow expedites the wetting process. Learn More
  4. MARSH FUNNEL

    MARSH FUNNEL

    Viscosity is a measurement of a fluids resistance to flow: the greater the resistance, the higher the viscosity. As measured by the Marsh Funnel, the viscosity of the fluid in question is influence by the density of the fluid (solids content) and gelation rate (beneficiated solids content). The viscosity of the drilling fluid in use should be based on a combination of the following parameters: Drilling rate, pump and output capacity, mud density, cuttings size, hole size and solids removal equipment. Learn More
  5. MUD BALANCE

    MUD BALANCE

    MUD BALANCE is used to determine the mud weight. Learn More
  6. PH STRIPS

    PH STRIPS

    pH is an expression of acidity or alkalinity of a solution measured between 0 and 14 with 7 being neutral. pH should be checked on a regular basis or when your water source changes with pH strips. pH is critical to optimizing your drilling fluid products and should be established and maintained between 8 and 9. Learn More
  7. SAND CONE

    SAND CONE

    Cuttings or solids held in suspension in drilling mud significantly influence the life of pumps, swivels, and hoses. These abrasive particles can be removed by using a sand cone (desander) working in conjunction with good drilling mud characteristics. Learn More

7 Item(s)

List Grid 
Set Direction